How to install resin tile in coastal areas scientifically and firmly?

How to install resin tile in coastal areas scientifically and firmly?

In China's coastal areas, almost every summer and autumn will be more or less affected by typhoons According to statistics, the annual landing of typhoons in our country an average of about 7 per year, usually in 5 to October synthetic resin tile as a popular roofing building materials on the market, how to install in order to better face the invasion of typhoon rain? Is there anything that needs attention ?

According to the main construction materials of the roof, it can be divided into three construction methods: cast-in-place reinforced concrete slope roof, wooden slope roof, steel structure slope roof, cast-in-place reinforced concrete slope roof: Whether there is a waterproof layer or no waterproof layer, the screed should be set up, the spacing of the joint should be 3m to 4m, the width of the joint is 20mm, and the concrete base should be filled with caulking materials to keep smooth, to ensure the installation and fixed quality of the embedded water strip hanging tile, so as to ensure the installation quality of the synthetic resin decorative tile If the water strip is needed, the water strip should be fixed on the embedded part, and then the hanging tile strip is fixed on the water strip. The fixing method can be welded bolts and self-tapping screws. The wooden slope roof is selected according to the actual installation: The thickness should be determined according to the distance between the hanging tiles, but should not be less than 12mm. 3mm to 5mm deformation joints should be reserved for paving between the panels. For example, when laying waterproof sheets on the panels, the sheets should be laid flat, vertical, accurately overlapping, without distortion, folding, or upper The lower layer and the adjacent two coil joints should be staggered plates and purlins (hanging shingles) or roof beams should be bolted galvanized nails or self-tapping wood screws to connect the steel structure roof: Steel roof should be smooth, in the production process should ensure that purlins in the same plane, to avoid the final roof uneven joints welding should be welded firmly, to prevent virtual welding steel should be selected to meet the standard products, and do anti-corrosion treatment.

Regardless of the structure and shape of the roof when installing the main tile, The bottom edge of the main tile should be close to the construction line, and the installation of the first tile from one side is the most important, it must be ensured that the bottom edge of the tile and the construction line shall not be perpendicular to the tilt position, and the center position of the tile at the bottom of the tile (wave peak) will be fixed The installation direction of the main tile should be opposite to the direction of the main monsoon of the local year round, and the horizontal one-way overlap to avoid drifting rain from the overlap. If the local monsoon is not serious, you can consider the sight direction of the main street and adopt a flexible installation method to ensure that the overall effect is more beautiful Consider a lap method, that is, the second tile suppresses the first tile and the third tile, the fourth tile suppresses the third and fifth tile and each lap a tile wave, and so on, it is recommended that the user in the construction of the roof structure in the selection of materials and more reinforcement of purlins strictly control the purlin spacing When installing the resin tile, use the supporting reaming screws, and reserve the space for thermal expansion and cold contraction when tightening the screws. The roof built will be a lot solid, and the ability to resist typhoons will be greatly strengthened. Where typhoons are often blown, the number of fixing screws can be increased according to actual needs, and the number of fixing screws can be increased to 6 per square meter when installing fixing screws.